Want to Know Your Plumbing Costs in Las Vegas?

Las Vegas Plumbing Repair Cost Guide

Hiring a plumber costs between $125 to $350 for small repairs like unclogging a toilet or fixing a leaky faucet, while bigger plumbing problems cost $500 to $800 to fix on average. Hourly rates average $45 to $150 to repair common issues such as faucets that drip, low water pressure, a toilet that runs or is broke, clogged drains, or problems with the water heater.

Plumbing Repair Costs

Many plumbers will also offer flat rates for small standard tasks, so you'll know how much you are going to pay without surprises. Here are typical plumbing project costs to expect.

Cost to Fix Leaking Pipes

Plumbers can fix a leaking pipe for $250 on average with homeowners spending between $150 to $850 which includes having to detect the location of the leak. Pipe leak repair cost varies depending on the location of the pipe. If it’s hard to access, it will cost more.

A leaking pipe needs fixing as quickly as possible. The water damage can only get worse, which adds to the bottom line of fixing this leak.

Pipe Bursting Repair Cost

Pipe bursting repair costs $100 to $200 per foot with most spending between $400 and $1,500 total. Water damage clean up and repair may add $1,000 to $2,000 in costs depending on the extent. Pipes burst for two main reasons, and both situations require immediate fixing.

1. A clog will exert excess pressure on the pipe
2. When the temperature falls below freezing, the frozen water expands, causing the pipe to burst.

Slab Leak Repair Cost

When a leak develops under the concrete foundation of your home, it can erode the soil and cause damage. Detecting an under slab leak costs about $150 to $400, whereas the cost to tear out the concrete, repair the pipe, and pour concrete again can cost $2,000 or more.

This cost may be the starting point. Once all that is taken care of, there is the cost to repair any damage done to your home or foundation.

Water Heater Repair Cost

Water heater repairs can run from $150 to $700. At some point, it might be wiser to replace the water heater, but many problems that arise can be repaired quickly and economically.

Garbage Disposal Repair Cost

Garbage disposal repairs cost between $180 and $240 on average with homeowners spending as little as $160 or as much as $370. One of the best ways to keep your garbage disposal in good working order is to keep certain foods out of it and run the hot water often. Be sure to keep eggshells, corn husks, bones, grease, onion skins, and pits from fruit out of your garbage disposal.

Gas Line Repair Cost

A plumber can repair a broken gas line for $150 to $650, or $6 to $7 per linear foot. Just like water pipes, gas lines can leak, and when they do, they must be fixed as soon as possible. The gas must be turned off to prevent a buildup of dangerous gas in your home.

Sump Pump Repair Cost

Sump pump repair costs $200 to $870 on average. The sump pump needs to function properly to keep low-level areas dry. Call your plumber if the pump is clogged, there’s no water in the basin, it’s making strange noises, it’s running continuously, or the pipes have burst.

Main Water Line Leak

Repairing a main water line leak will cost between $450 and $2,500 depending on if it needs to be replaced or not. The main water line is responsible for bringing water to your home from the city line. A break in the main can cause flooding in your yard, and many times all water entering the house will be contaminated. You’ll need to have excavation done to access the pipe, which can cost from $40 to $200 per cubic yard of dirt moved.

Cost to Repair Leaking Pipe in Ceiling

You can expect to pay between $700 to $2,500 to repair a leaking pipe in the ceiling. The leak will first have to be located - just because there is a leak dripping from the ceiling doesn’t mean that’s where the problem is.

There may be drywall that needs replacing in addition to fixing or replacing the leaky pipe/fixture. This repair is something you’ll want to do immediately to avoid mold growth in the wet areas. The average cost to install drywall for your ceiling is between $1.60 and $2.35 per square foot.

Clogged Drain Repairs – Sink, Bathtub, Shower

The plumber cost to unclog a drain is $100 to $275 on average. Soap residue, hair, and other things clog drains slowly as debris builds. You’ll notice the sink taking longer to drain until it finally won’t drain at all.

Try plunging it before calling a plumber, and avoid using harsh chemicals on older pipes - you might cause the already corroding pipes to fall apart from the chemicals.

Sewer Line and Septic System Repairs

Septic systems need to be kept in good condition because when they malfunction, they can cause an expensive mess. They need to fixed immediately to prevent from contaminating the groundwater with bacteria from the septic tank or sewer line.

Septic Tank Cleaning Costs

The cost to clean a septic tank runs from $275 to $580 on average. Depending on the size of your septic tank, pumping could cost as low as $250 for a 750-gallon tank, or as high as $650 for a 2,000-gallon tank. The septic tank pumping cost guide covers each size in detail and many pricing factors.

Toilet Repair Cost

Toilet repairs from a professional plumber cost $130 to $310 on average. For around $150, a pro can fix either the flapper and chain adjustment, the toilet flange, flush valve, or wax ring. Many repairs are fairly simple and can cost as little as $20 to fix it yourself.

Average Cost to Replace Plumbing

Replacing plumbing costs $200 to $500 for small projects such as replacing a sink or toilet, and $2,000 to $15,000 to install new plumbing or repipe an entire home.

Cost to Install New Plumbing Fixtures

The average cost to install new plumbing fixtures ranges from $150 to $500 depending on the brand and style of fixture, and the location of your project.

• New sink installation costs $250 to $500 on average.
• Toilet installation pricing ranges from $250 to $750 depending on the type of toilet.

Faucet Replacement Costs

Faucet replacement costs $120 to $300 on average, depending if it's for a kitchen, bathroom, or bathtub. Outdoor faucets cost $50 to $150 for a basic replacement. Installing a bathroom or kitchen sink and faucet combo costs $400 to $1,000.

Bathtub and Shower Replacement Cost

Replacing your bathtub will cost $800 to $4,600, while a shower replacement ranges from $2000 to $9,000 on average. Shower or bathtub liners cost between $1,700 and $2,500 for materials and installation from a general contractor.

Also, you can have the drain replaced in a tub or shower for $200 to $700, the shower control valve replaced for $225 to $575, and the shower head can be replaced for $75 to $275.

Replace Water Pressure Regulator Cost

The cost to replace a water pressure regulator is $150 to $350 and takes about three hours to install. Regulating your water pressure keeps your pipes in good condition. Too much water pressure will cause undue strain on pipes, resulting in cracks and leaks. You can get a pressure regulator at your local home improvement store for about $85.

Main Water Shut-Off Valve

You can shut off the water to the entire house with the main water shut-off valve, which is a building code requirement in all homes. The main water valve replacement cost is about $185 when done by a plumbing contractor.

Replace Plumbing Stack

A plumber’s average price of replacing the main plumbing stack with PVC is $1,500, while cast iron or steel stacks cost up to $4,000. A drain stack is a pipe that funnels all water from all the drains and toilets in the house. If the drain stack becomes clogged, it will halt the water operation in the entire house.

Well Pump Replacement Cost

Replacing a well pump costs between $750 and $2,750 on average. A well pump sends the water from the well into your home. If it’s malfunctioning, maybe all you need is a repair for a cost of $500 to $800. There are a few ways you’ll know if it’s going bad.

• Do you hear strange noises connected to water flow?
• Are your faucets spitting water?
• Are there high fluctuations in water pressure throughout your home?

Cost To Replace Sink Drain Pipes

The cost to replace the bathroom or kitchen sink drain pipes is $100 to $350 on average. When older drains leak and smell, they need replacing.

Cost to Replace P Trap

The cost to replace a P-trap ranges from $150 to $250 on average. A sink trap is a U-shaped pipe that holds a little bit of water in the base of the U. This water blocks odors from drains and sewers from coming into your home. If you notice sewer odors, you may need to have the P-trap replaced.

Water Heater Installation Cost

Water heater installation prices depend on whether it's electric, gas, tankless, or solar.

Well Holding Tank Replacement

Replacing a well holding tank costs between $1,600 and $2,600 for both the materials and professional installation. The cost for a new water pressure tank is around $500 to $1,000 for just the tank.

The well water tank or pressure tank stores several gallons of water between your well pump and your home. A well ensures water is immediately available and saves wear and tear on the well pump. You’ll notice some of the following if you have pressure tank problems:

• Low or unstable water pressure.
• The well pump cycles off and on, quite often.
• The pressure tank is leaking.
• Corrosion on the outside of the pressure tank.
• Air is in the plumbing system.

Whole House Plumbing Cost Calculator

The total cost to install rough-in plumbing and fixtures in a 2,000 square foot home with 3 baths is about $12,000 to $20,000. Replumbing and replacing plumbing pipes cost $2,500 to $5,500 on average. The following installation prices are based on a new construction house of 2,000 square feet.

Costs are not based solely on square footage but also on the number of fixtures in the home. Each fixture adds to the price, so new sinks, toilets, showers, dishwashers, and water softeners add to the bottom line.

Rough-In Plumbing Cost

The cost to install rough-in plumbing pipes for new construction costs $4.50 per square foot on average. Rough-in plumbing costs for a 2,000 square foot home is about $9,000, and once you add in the fixture hookup costs expect to spend $12,000 to $15,000 total. Rough-in plumbing is all the pipework that is laid under the house and in the walls and ceiling. No fixtures have been attached; this is just the pipe foundation.

Plumbing Prices Per Fixture

Plumbing prices per fixture average $300 to $800, so a 2-bath home with one kitchen, a water heater, a fridge, and a washing machine could cost $3,000 to $8,000 to plumb with new pipes. Every item that requires a water hookup is considered a fixture. This is a rough pricing guide only, and your pricing will depend on many factors.

Rerouting Plumbing Prices

Rerouting a single plumbing line will cost about $700 while repiping a whole house will cost between $3,900 and $7,500. If you must move plumbing fixtures such as sinks, toilets, bathtubs, or showers, it’s worth designing a plan that makes the best use of existing pipework rather than digging into the slab.

Plumbing Inspection Cost

A plumbing inspection costs from $85 to $300, with most spending about $200. If you’re purchasing a new home, plumbing inspections are a good idea. Roots can invade pipes or have other blockages you’ll need to know about before buying.

This information shared here at Plumbing Costs Las Vegas is from homeguide.com

Looking for an affordable plumber in Las Vegas? Read more here.